ReaPitch timing problem when automating Shift (FIXED)

Hey, We've come across a timing issue when automating the Shift (Full Range) parameter on ReaPitch. If we use automation to drop the pitch, and then come back up to 0 with a vertical line, the audio is then out of time. We confirmed this by placing the original track in the left ear and a duplicate of the track with the pitch shifting applied in the right ear. If the automation line returning to 0 is on a very slight angle, this does not seem to occur. Regards, Mark Coleman

Only seems to have the most severe bug (Dstruct's) on E2 pro.. can anybody do it on another mode?

I just open reapitch-bug.RPP in Reaper 3 alpha2b. As you described, it plays only until the env goes to zero and all following beats are silent. But, when I opened the project, it opened in a tab, next to the project I had been working on... After starting playback of your project and having it go silent half way through, when I switch to the other project in the other tab, your project instantly resumes playback, and repeats normally (I listened through to about a dozen repeats.) Then, when I switch back to the repitch-bug.RPP tab, it plays for one or two iterations, and then goes silent half way through. I can't swear to this... but It has sometimes appeard that whether or not it loops with audio when switching back from the other project depends on when in the loop cycle I swtich: If I switch during the down slope, the audio stops when it jumps back, but if I switch in the second half it will play for a repeat or two. Or so it seems. Dunno it that's of any help, but there you go. PS I did not change the algorithm from what it was set to upon opening when I did this. (BTW, being able to have multiple projects in tabs is fantastic!)

Not fixed yet (in 3.alpha3) ... FIXED (3.161)

Deserves a bump. FIXED (3.161)